V.S. on-board TWIN Glow Plug Driver (LiPo 2S/3S)

Description

Twin version of on-board glow plug driver for nitro powered engines, installed on airplane, helicopter or car models. You can use small and light 1000-1600 mAh 2S1P LiPo's or LiFe's for multiple engine
starts
and
flights
(approximately 10 flights with one 1000 mAh 2S LiPo pack, depending on settings).
This version does not include glow plug adapters.
There is version with glow plug adapters, and versions for single cylinder engines
, you can find them
in my items for sale list
.
Features
:
with glow plug driver properly configured (especially in automatic mode), engine works much more stable in idle mode all the time during flight and on the ground, even with very
rich settings of
idle needle. It makes configuring of idle needle much easier even on cheap engines. On the other hand, you can finely tune the engine, and reach very low yet stable idle RPMs with glow driver on 4-cycle engine, if needed;
works with following types of power batteries: LiPo (2-, 3-cell), LiFe (2-, 3-cell);
auto detection of
power battery type
;
two modes of operation:
automatic, in four ranges of throttle stick (throttle cut-off, idle, middle RPM's, high RPM's). Glow Driver is connected
in parallel
with throttle servo via Y-Harness;
controlled by Transmitter (Tx) switch. Glow Driver is connected to individual Receiver (Rx) channel;
glow level is sustained during lowering of LiPo battery voltage;
two-step indication of lowering voltage for LiPo batteries, full discharge indication for all supported batteries. Power battery cut-off on discharge (optional), saving LiPo battery from being over-discharged;
settings are stored in nonvolatile memory;
automatic reverse recognition
;
indication of glow plug chain disconnection;
glow level is adjustable;
glow plug may be heated when throttle changes from middle or idle range to high range (option may be disabled, or set to 50- or 100-percent heating for 2 seconds);
one-button
configurable via audio/LED menu;
operating voltage 4.8-13 V;
manual glow on button press.
Specifications
:
weight (without female T-plug, male 3.5 mm plugs and extension wire) -
35
g;
PCB size -
41
x25 mm;
case size (with the shrink wrap) - 5
2
x26x16 mm;
power battery plug type - T-plugs;
receiver plug type - Futaba or JR;
bright, 5 mm LEDs. Visible in the daylight. Wire length - 24 cm;
button with lockwasher and nut.
Wire length - 24 cm;
extension wire: length - 40 cm, 18AWG, silicone insulation;
crankcase clamp for 3,5 mm screw;
glow plug wire connectors - 3.5 mm
.
Item will be shipped within 10 business days after payment, with international tracking number.
If you have errors during checkout, such as "Something went wrong. Please try to check out again.", please try to remove saved credit card information.
Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility.
Please check with your country's customs office to determine what these additional costs will be prior to
buying
.